H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 165)

11-30
[AC-nqa-admin-test-http] url /index.htm
# configure the HTTP version 1.0 to be used in HTTP tests. (Version 1.0 is the default version, and this
step can be omitted.)
[AC-nqa-admin-test-http] http-version v1.0
# Enable the saving of history records.
[AC-nqa-admin-test-http] history-record enable
[AC-nqa-admin-test-http] quit
# Start HTTP tests.
[AC] nqa schedule admin test start-time now lifetime forever
# Stop HTTP tests after a period of time.
[AC] undo nqa schedule admin test
# Display results of the last HTTP test.
[AC] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 64/64/64
Square-Sum of round trip time: 4096
Last succeeded probe time: 2007-11-22 10:12:47.9
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors:
Packet(s) arrived late: 0
# Display the history of HTTP tests.
[AC] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 64 Succeeded 2007-11-22 10:12:47.9
UDP Jitter Test Configuration Example
Network requirements
As shown in Figure 11-8 , configure NQA UDP jitter tests to test the delay jitter of packet transmission
between AC and Device.
Figure 11-8 Network diagram for UDP jitter tests