H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 141)

11-6
Task Remarks
Configuring ICMP Echo Tests
Configuring DHCP Tests
Configuring DNS Tests
Configuring FTP Tests
Configuring HTTP Tests
Configuring UDP Jitter Tests
Configuring SNMP Tests
Configuring TCP Tests
Configuring UDP Echo Tests
Configuring an NQA Test Group
Configuring Voice Tests
Required
Use any of the approaches
Configuring the Collaboration Function Optional
Configuring Threshold Monitoring Optional
Configuring the NQA Statistics Collection Function Optional
Configuring the History Records Saving Function Optional
Configuring Optional Parameters for an NQA Test Group Optional
Scheduling an NQA Test Group Required
Configuring the NQA Server
To perform TCP, UDP echo, UDP jitter, or voice tests, configure the NQA server on the peer device. The
NQA server responses to the probe packets sent from the NQA client by listening to the specified
destination address and port number.
Follow these steps to configure the NQA server:
To do… Use the command… Remarks
Enter system view system-view —
Enable the NQA server nqa server enable
Required
Disabled by default.
Configure the listening service
nqa server { tcp-connect |
udp-echo } ip-address
port-number
Required
The destination IP address and port
number must be the same as those
configured on the NQA client. A
listening service must be unique on
the NQA server.
Enabling the NQA Client
Configurations on the NQA client take effect only when the NQA client is enabled.
Follow these steps to enable the NQA client: