H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 154)

11-19
To do… Use the command… Remarks
Configure optional parameters
See Configuring Optional
Parameters for an NQA Test
Group Optional
Only one probe operation is performed in one voice test.
Configuring the Collaboration Function
Collaboration is implemented by establishing reaction entries to monitor the detection results of a test
group. If the number of consecutive probe failures reaches the threshold, the configured action is
triggered.
Follow these steps to configure the collaboration function:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Enter test type view of the test
group
type { dhcp | dns | ftp | http |
icmp-echo | snmp | tcp |
udp-echo } The collaboration function is not
supported in UDP jitter and voice
tests.
Configure a reaction entry
reaction item-number
checked-element probe-fail
threshold-type consecutive
consecutive-occurrences
action-type trigger-only Required
Not created by default.
You cannot modify the content of
an existing reaction entry.
Exit to system view quit —
Configure a track entry and
associate it with the reaction entry
of the NQA test group track entry-number nqa entry
admin-name operation-tag
reaction item-number
Required
Not created by default.
Configuring Threshold Monitoring
Configuration prerequisites
Before you configure threshold monitoring, complete the following tasks:
z Configure the destination address of the trap message by using the snmp-agent target-host
command. For more information about the snmp-agent target-host command, see SNMP in the
Network Management and Monitoring Command Reference.
z Create an NQA test group and configure related parameters.
Configuring threshold monitoring
Follow these steps to configure threshold monitoring: