H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 119)

10-5
Configurations for the eight output destinations function independently and take effect only after the
information center is enabled.
Outputting System Information by Source Module
The system is composed of a variety of protocol modules, board drivers, and configuration modules.
The system information can be classified, filtered, and output according to source modules. You can
use the info-center source ? command to view the supported information source modules.
Default Output Rules of System Information
The default output rules define the source modules allowed to output information on each output
destination, the output information type, and the output information level as shown in Table 10-3 , which
indicates that by default and in terms of all modules:
z All log information is allowed to be output to the Web interface and log file; log information with
severity level equal to or higher than informational is allowed to be output to the log host; log
information with severity level equal to or higher than warning is allowed to be output to the console,
monitor terminal, and log buffer; log information is not allowed to be output to the trap buffer and the
SNMP module.
z All trap information is allowed to be output to the console, monitor terminal, log host, Web interface,
and log file; trap information with severity level equal to or higher than warning is allowed to be
output to the trap buffer and SNMP module; trap information is not allowed to be output to the log
buffer.
z All debugging information is allowed to be output to the console and monitor terminal; debugging
information is not allowed to be output to the log host, trap buffer, log buffer, the SNMP module,
Web interface, and log file.
Table 10-3 Default output rules for different output destinations
LOG TRAP DEBUG
Output
destination
Modules
allowed Enabled/d
isabled
Severity
Enabled/d
isabled
Severity
Enabled/d
isabled
Severity
Console
default (all
modules)
Enabled Warning Enabled Debug Enabled Debug
Monitor
terminal default (all
modules)
Enabled Warning Enabled Debug Enabled Debug
Log host
default (all
modules)
Enabled
Information
al
Enabled Debug Disabled Debug
Trap buffer
default (all
modules)
Disabled
Information
al
Enabled Warning Disabled Debug
Log buffer
default (all
modules)
Enabled Warning Disabled Debug Disabled Debug
SNMP
module default (all
modules)
Disabled Debug Enabled Warning Disabled Debug