H3C Technologies H3C MSR 3600 - Manual (Page 68)

60
Figure 88 Installing a filler panel
Replacing a MIM
WARNING!
You can replace a MIM when the router is powered on. However, before replacing a MIM when the router
is powered on, you must execute the remove hmimslot
slotnumber command.
To replace a MIM:
1. Completely loosen the captive screws of the HMIM adapter.
2. Gently pull the MIM and the HMIM adapter out of the slot along the slide rails.
Figure 89 Removing a MIM and the HMIM adapter
3. Completely loosen the captive screws of the MIM, remove the screws that secure the MIM to the
HMIM adapter, and pull the MIM out of the HMIM adapter along the slide rails.
Keep the removed MIM for future use.
4. Install a new MIM. For the installation procedure, see " Installing the router ."
If you do not install a new MIM in the slot, install a filler panel and tighten the screws.