H3C Technologies H3C MSR 3600 - Manual (Page 38)

30
Installing a MIM
IMPORTANT:
•
To install a MIM, install it to the HMIM adapter and then insert it into the HMIM slot.
• You can install a MIM when the router is powered on. However, before replacing a MIM when the router
is powered on, you must execute the remove hmimslot
slotnumber command.
• If you install MIMs on both of the HMIM slots on an MSR 36-20, when you insert a MIM to the upper
slot, slightly press down the MIM, and then push it into the slot.
The MSR3600-28/3600-51 router does not support MIMs.
A MIM can be 1 U or 0.5 U. When you install a 1 U MIM to an MSR router, remove the filler panels of
the target slot and the neighboring slot above, and use the 1 U HMIM adapter. This section uses a 0.5
U MIM as an example.
To install a MIM:
1. Remove the fastening screws on the filler panel in the HMIM slot with a Phillips screwdriver to
remove the filler panel.
2. Push the MIM slowly along the slide rails of the HMIM adapter until it makes close contact with the
backplane of the HMIM adapter.
3. Fasten the fastening screws.
4. Fasten the captive screws on the MIM to secure it to the HMIM adapter.
5. Push the MIM into the HMIM slot along the slide rails until it makes close contact with the
backplane of the router.
6. Fasten the captive screws to secure the MIM to the router.
Figure 37 Attaching a MIM to an HMIM adapter
Figure 38 Installing the MIM to the router