H3C Technologies H3C MSR 3600 - Manual (Page 66)

58
To replace a DSIC:
1. Completely loosen the captive screws of the DSIC.
2. Gently pull the DSIC out along the slide rails.
If you need to install SIC or DSIC interface modules, see "
Installing the router " for the installation
procedure.
To install filler panels, proceed to steps 3 and 4.
3. Gently push the slot divider into the DSIC slot along the slide rails and tighten the screws.
4. Install filler panels and tighten the screws.
Figure 84 Removing a DSIC
Figure 85 Installing a slot divider