H3C Technologies H3C MSR 3600 - Manual (Page 40)

32
4. Identify the Rx and Tx ports. Plug the LC connector at one end of one fiber cable into the Rx port
of the router and the LC connector at the other end into the Tx port of the peer device. Plug the LC
connector at one end of another fiber cable into the Tx port of the router and the LC connector at
the other end to the Rx port of the peer device.
5. Examine the Ethernet port LED after connection. For more information, see " Appendix B LEDs ."
Figure 40 Connecting an optical fiber
Installing a CF card
The MSR 36-10 and MSR3600-28/3600-51 routers do not support external CF cards.
To install a CF card:
1. Open the CF card cover by pressing the spring clip.
2. Push the CF card eject button all the way into the slot, and make sure the button does not project
from the panel.
3. Insert the CF card into the slot following the direction shown in Figure 41 , and make sure it does
not project from the slot.
4. Close the CF card cover.