H3C Technologies H3C MSR 3600 - Manual (Page 50)

42
Figure 58 Connecting an AC power cord to an MSR3600-28/3600-51 router
Connecting a DC power cord
WARNING!
Pay attention to the mark on a power cord to avoid connection errors.
H3C recommends that you use the DC power cord provided with the router. The MSR3600-28 router
does not support DC power cords.
The MSR 36-10/36-20 router, the MSR 36-40/36-60 router, and the MSR3600-28/3600-51 router use
different DC connectors, but the power cord connection procedures are the same.
To connect DC power cords:
1. Make sure the router is correctly grounded, and the power switch on the router is in the OFF
position.
2. Loosen the captive screws on the power module with a Phillips screwdriver to remove the power
module connector.
3. Connect one end of the DC power cord supplied with the router to the DC receptacle on the router,
and the other end to the DC power source.
Figure 59 Connecting a DC power cord for an MSR 36-10/36-20
1 2