H3C Technologies H3C SR8800 User Manual
Page 90
80
CAUTION:
Do not remove the CF card when the router is booting or the CF card LED is flashing. Otherwise, the file
system on the hardware or the CF card may be damaged.
To replace the CF card when the CF card memory is insufficient or the CF card is damaged:
1.
Examine the CF card LED status.
{
If the LED is on, you cannot remove the CF card. You must unmount the CF card at the CLI and
wait until the CF card LED is off before removing the CF card.
{
If the LED is flashing, it means that the CF card is reading and writing data. In this case, you
cannot remove the CF card. Wait until the CF card LED stops flashing before removing it.
{
If the LED is off, it means that the CF card has been unmounted, and you can remove it.
After you execute the umount cf command, if you want to continue to use the CF card, execute the
mount cf command in user view to load the CF card again. For more information about the umount
and mount commands, see H3C SR8800 Router Series Fundamentals Command Reference.
2.
Use a Phillips screwdriver to loosen the screw at the right side of the CF card cover, and pull the
CF card cover outward.
3.
Press the eject button of the CF card reader. The reader ejects the card part way out of the slot.
Remove the CF card from the reader, and put the removed CF card in an antistatic bag or its
original shipping materials.
4.
Push the new CF card all the way into the CF card slot so that it does not automatically project. At
the same time, the eject button projects.
IMPORTANT:
Before inserting the CF card, make sure the CF card eject button is all the way into the slot and does
not project from the panel.
5.
Push the CF card cover inward.
6.
Use a Phillips screwdriver to fasten the screw at the right side of the CF card cover.