Spc card leds, Link/act led, Combo interface led – H3C Technologies H3C SR8800 User Manual
Page 113
103
shows the LED description of an SR02SRP1F3/SR02SRP2F3 MPU.
Table 47 MPU status LED description
LED Status
Description
SFS (green)
Steady on
The switching fabric module is in the operating state, or is
starting up.
Off
The switching fabric module is in the standby state.
ACT (green)
Steady on
The MPU is in active state.
Off
The MPU is in standby state.
RUN (green)
Flashing (eight times
per second)
The MPU is in registration state, or is starting up.
Flashing (one time per
second)
The MPU is operating correctly.
Steady on
The MPU is faulty.
Off
The MPU is faulty or not in position.
ALM (red)
Steady on
An alarm has occurred.
Off
No alarm has occurred.
SPC card LEDs
The description of the SPC card LEDs varies by card models.
LINK/ACT LED
Each interface on the following SPC cards has a LINK/ACT LED:
•
SPC-GT48L
•
SPC-GT48LA
Table 48 Interface LED description
LED Status
Description
LINK/ACT (green)
Steady on
The interface is connected.
Off
The interface is not connected correctly.
Flashing
Data is being transmitted and/or received on the interface.
Combo interface LED
The SPC-GP24L or SPC-GP24LA provides combo interfaces. Each copper or fiber combo interface has a
LED. On the SPC-GP24L or SPC-GP24LA, the GE fiber ports are numbered from 1 to 16. For the LED
description, see
. The fiber ports are numbered from 17 to 24, and the copper ports are
numbered from 25 to 32. For the LED description, see