H3C Technologies H3C SR8800 - Manual (Page 62)

52
Table 17 Allowed maximum tensile force and crush load
Period of force Tensile load (N) Crush load (N/100 mm)
Short period 150 500
Long term 80 100
Installing a transceiver module
CAUTION:
Do not touch the golden finger of an SFP module during installation.
The installation procedures of an XFP module and SFP module are similar. The following uses an SFP
module as an example.
To install an SFP module:
1. Put on an ESD wrist strap, and make sure it makes good skin contact, and is correctly grounded.
2. Unpack the SFP module. Close the clasp by pushing it up over the SFP module, and then gently
insert the SFP module into the interface slot until it clicks into place, as shown in
Figure 50 .
Figure 50 Installing an SFP module
IMPORTANT:
•
Do not remove the dust plug of the SFP module port before installing an optical fiber.
• For an SFP module installed with an optical fiber, remove the fiber before you install the SFP module into
the slot.
Connection procedure
1. Put on an ESD wrist strap, and make sure it makes good skin contact, and is correctly grounded.
2. Remove the protective cap from the fiber connector, and use dust free paper and absolute alcohol
to clean the end face of the fiber connector.
3. Connect one end of the fiber to the SFP module of the router.
4. Connect the other end of the fiber to the peer device.