H3C Technologies H3C SR8800 - Manual (Page 38)

28
Figure 22 Installing the cage nuts
NOTE:
When preparing for installation, make sure the total height of the routers to be installed is no higher than
the height of the rack, and reserve enough clearance for cable routing.
Installing the cable management brackets
Installing the cable management brackets on the SR8808
The SR8808 has two cable management brackets. The signal cable management brackets are installed
at the upper part of the router, and the power cord management brackets are installed at the lower part
of the router. They are installed in the same way.
To install a cable management bracket:
1. Attach the cable management bracket to the chassis, and align the screw holes on the cable
management bracket with the screw holes on the chassis, as shown in
Figure 23 .
2. Screw in the M4 screws with a screwdriver, and fasten the screws.