Multiport arp entry configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S12500-X Series Switches User Manual
Page 20: Enabling dynamic arp entry check, Configuring a customer-side port
9
IP address MAC address VLAN Interface Aging Type
192.168.1.1 00e0-fc01-0000 10 XGE1/0/1 N/A S
Multiport ARP entry configuration example
Network requirements
As shown in
, a switch connects to three servers through interfaces Ten-GigabitEthernet1/0/1,
Ten-GigabitEthernet1/0/2, and Ten-GigabitEthernet1/0/3 in VLAN 10. The servers share the IP
address 192.168.1.1/24 and MAC address 00e0-fc01-0000.
Configure a multiport ARP entry to send IP packets with destination IP address 192.168.1.1 to the three
servers.
Figure 4 Network diagram
Configuration procedure
# Create VLAN 10.
[Switch] vlan 10
[Switch-vlan10] quit
# Add Ten-GigabitEthernet1/0/1, Ten-GigabitEthernet1/0/2, and Ten-GigabitEthernet1/0/3 to VLAN
10.
[Switch] interface Ten-GigabitEthernet 1/0/1
[Switch-Ten-GigabitEthernet1/0/1] port access vlan 10
[Switch-Ten-GigabitEthernet1/0/1] quit
[Switch] interface Ten-GigabitEthernet 1/0/2
[Switch-Ten-GigabitEthernet1/0/2] port access vlan 10
[Switch-Ten-GigabitEthernet1/0/2] quit
[Switch] interface Ten-GigabitEthernet 1/0/3
[Switch-Ten-GigabitEthernet1/0/3] port access vlan 10
[Switch-Ten-GigabitEthernet1/0/3] quit
# Create VLAN-interface 10 and specify its IP address.
[Switch] interface vlan-interface 10