H3C Technologies H3C S12500 Series Switches User Manual

Page 245

231

# Configure interface GigabitEthernet 3/0/1.

system-view

[SwitchA] ipv6

[SwitchA] vlan 100

[SwitchA-vlan100] port GigabitEthernet 3/0/1

[SwitchA-vlan100] quit

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ipv6 address 3001::1 64

[SwitchA-Vlan-interface100] quit

# Configure interface GigabitEthernet 3/0/2, the physical interface of the tunnel.

[SwitchA] vlan 101

[SwitchA-vlan101] port GigabitEthernet 3/0/2

[SwitchA-vlan101] quit

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] ip address 1.1.1.1 255.255.255.0

[SwitchA-Vlan-interface101] quit

# Create a tunnel interface Tunnel1.

[SwitchA] interface tunnel 1

# Configure an IPv6 address for the tunnel interface.

[SwitchA-Tunnel1] ipv6 address 2001::1 64

# Configure the tunnel encapsulation mode as GRE over IPv4.

[SwitchA-Tunnel1] tunnel-protocol gre

# Configure a source address for the tunnel interface (IP address of the VLAN interface to which
GigabitEthernet 3/0/2 belongs).

[SwitchA-Tunnel1] source 1.1.1.1

# Configure a destination address for the tunnel interface (IP address of the VLAN interface to

which GigabitEthernet 3/0/2 of Switch B belongs).

[SwitchA-Tunnel1] destination 1.1.1.2

[SwitchA-Tunnel1] quit

# Configure a static route from Switch A through tunnel interface Tunnel1 to Group 2.

[SwitchA] ipv6 route-static 3002:: 64 tunnel 1

Configure Switch B:
# Configure interface GigabitEthernet 3/0/1.

system-view

[SwitchB] ipv6

[SwitchB] vlan 100

[SwitchB-vlan100] port GigabitEthernet 3/0/1

[SwitchB-vlan100] quit

[SwitchB] interface vlan-interface 100

[SwitchB-Vlan-interface100] ipv6 address 3002::1 64

[SwitchB-Vlan-interface100] quit

# Configure interface GigabitEthernet 3/0/2, the physical interface of the tunnel.

[SwitchB] vlan 101

[SwitchB-vlan101] port GigabitEthernet 3/0/2

[SwitchB-vlan101] quit

[SwitchB] interface vlan-interface 101

This manual is related to the following products: