Verifying the configuration – H3C Technologies H3C S12500 Series Switches User Manual

Page 221

207

# Configure an IPv6 manual tunnel.

[SwitchB] interface tunnel 0

[SwitchB-Tunnel0] ipv6 address 3001::2/64

[SwitchB-Tunnel0] source vlan-interface 100

[SwitchB-Tunnel0] destination 192.168.100.1

[SwitchB-Tunnel0] tunnel-protocol ipv6-ipv4

[SwitchB-Tunnel0] quit

# Configure a static route to IPv6 Group 1 through tunnel 0 on Switch B.

[SwitchB] ipv6 route-static 3002:: 64 tunnel 0

Verifying the configuration

# Display the status of the tunnel interfaces on Switch A and Switch B.

[SwitchA] display ipv6 interface tunnel 0

Tunnel0 current state :UP

Line protocol current state :UP

IPv6 is enabled, link-local address is FE80::C0A8:6401

Global unicast address(es):

3001::1, subnet is 3001::/64

Joined group address(es):

FF02::1:FF00:0

FF02::1:FF00:1

FF02::1:FFA8:6401

FF02::2

FF02::1

MTU is 1480 bytes

ND reachable time is 30000 milliseconds

ND retransmit interval is 1000 milliseconds

Hosts use stateless autoconfig for addresses

IPv6 Packet statistics:

InReceives: 55

...

[SwitchB] display ipv6 interface tunnel 0