H3C Technologies H3C S12500 Series Switches - Manual (Page 103)

89
Figure 39 Network diagram
Configuration procedure
# Configure a mapping between host name host.com and IP address 10.1.1.2.
system-view
[Sysname] ip host host.com 10.1.1.2
# Execute the ping host.com command to verify that the device can use the static domain name resolution
to get the IP address 10.1.1.2 corresponding to host.com.
[Sysname] ping host.com
PING host.com (10.1.1.2):
56 data bytes, press CTRL_C to break
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=128 time=1 ms
Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=128 time=4 ms
Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=128 time=3 ms
Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=128 time=2 ms
Reply from 10.1.1.2: bytes=56 Sequence=5 ttl=128 time=3 ms
--- host.com ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/2/4 ms
Dynamic domain name resolution configuration example
Network requirements
As shown in Figure 40 , the IP address of the DNS server is 2.1.1.2/16 and the name suffix is com. The
mapping between domain name Host and IP address 3.1.1.1/16 is stored in the com domain.
Device serves as a DNS client, and uses the dynamic domain name resolution and the suffix to access the
host with the domain name host.com and the IP address 3.1.1.1/16.
Figure 40 Network diagram