H3C Technologies H3C S12500 Series Switches - Manual (Page 65)

52
Network requirements
As shown in Figure 15 :
• The MAC address of Host A is 000f-e235-dc71 and belongs to VLAN 1. It is connected to
GigabitEthernet 3/0/1 of the switch. To prevent MAC address spoofing, add a static entry for the
host in the MAC address table of the switch.
• The MAC address of Host B is 000f-e235-abcd and belongs to VLAN 1. For security, because this
host once behaved suspiciously on the network, add a destination blackhole MAC address entry for
the host MAC address, so all packets destined for the host will be dropped.
• Set the aging timer for dynamic MAC address entries to 500 seconds.
Figure 15 Network diagram
Configuration procedure
# Add a static MAC address entry.
system-view
[Sysname] mac-address static 000f-e235-dc71 interface Gigabitethernet 3/0/1 vlan 1
# Add a destination blackhole MAC address entry.
[Sysname] mac-address blackhole 000f-e235-abcd vlan 1
# Set the aging timer for dynamic MAC address entries to 500 seconds.
[Sysname] mac-address timer aging 500
# Display the MAC address entry for port GigabitEthernet 3/0/1.
[Sysname] display mac-address interface Gigabitethernet 3/0/1
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
000f-e235-dc71 1 Config static GigabitEthernet3/0/1 NOAGED
--- 1 mac address(es) found on port GigabitEthernet3/0/1 ---
# Display information about destination blackhole MAC addresses.
[Sysname] display mac-address blackhole
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
000f-e235-abcd 1 Blackhole N/A NOAGED
--- 1 mac address(es) found ---