Configuration consideration, Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual

Page 32

Figure 8 Network diagram

Configuration consideration

Create VLANs 100 and 200. Associate VLAN 100 with IPv4, and VLAN 200 with IPv6. Configure

protocol-based VLANs to isolate IPv4 traffic and IPv6 traffic at Layer 2.

Configuration procedure

Configure Device:
# Create VLAN 100, and assign port GigabitEthernet 3/0/11 to VLAN 100.

system-view

[Device] vlan 100

[Device-vlan100] description protocol VLAN for IPv4

[Device-vlan100] port GigabitEthernet 3/0/11

# Create VLAN 200, and assign port GigabitEthernet 3/0/12 to VLAN 200.

[Device-vlan100] quit

[Device] vlan 200

[Device-vlan200] description protocol VLAN for IPv6

[Device-vlan200] port GigabitEthernet 3/0/12

# Create an IPv6 protocol template in the view of VLAN 200, and an IPv4 protocol template in the
view of VLAN 100.

[Device-vlan200] protocol-vlan 1 ipv6

[Device-vlan200] quit

[Device] vlan 100

[Device-vlan100] protocol-vlan 1 ipv4

[Device-vlan100] quit

# Configure port GigabitEthernet 3/0/1 as a hybrid port that forwards packets of VLANs 100
and 200 untagged.

[Device] interface gigabitethernet 3/0/1

[Device-GigabitEthernet3/0/1] port link-type hybrid

This manual is related to the following products: