H3C Technologies H3C S12500 Series Switches - Manual (Page 172)

159
Step Command Remarks
2. Configure one class for a CVLAN
and a SVLAN.
a. Create a class and enter class
view:
traffic classifier tcl-name
[ operator { and | or } ]
b. Specify one CVLAN as the
match criterion:
if-match customer-vlan-id
vlan-id-value
c. Specify one SVLAN as the
match criterion:
if-match service-vlan-id
vlan-id-value
d. Return to system view:
quit
Repeat these steps to
create one class for each
CVLAN and foreign
SVLAN pair.
3. Configure one behavior for an
SVLAN.
a. Create a traffic behavior and
enter traffic behavior view:
traffic behavior
behavior-name
b. Configure an SVLAN marking
action to replace the foreign
SVLAN ID with a local SVLAN
ID:
remark service-vlan-id
vlan-id-value
c. Return to system view:
quit
Repeat these steps to
configure one SVLAN
marking action for each
CVLAN and foreign
SVLAN pair.
4. Create a QoS policy and enter
QoS policy view.
qos policy policy-name N/A
5. Associate the class with the
behavior. classifier tcl-name behavior
behavior-name
Repeat this step to create
other class-behavior
associations.
6. Return to system view. quit N/A
Configuring the customer-side port
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Ethernet interface view.
interface interface-type
interface-number
N/A
3. Configure the link type of the port.
• Configure the port as a trunk
port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
The default link type of an
Ethernet port is access.