H3C Technologies H3C S12500 Series Switches - Manual (Page 156)

143
Step Command Remarks
11. Enter interface view or port
group view.
• Enter Ethernet interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either command.
12. Apply the QoS policy to the
incoming traffic on the port.
qos apply policy policy-name
inbound
N/A
Configuring an inner-outer VLAN 802.1p priority mapping
policy
To map different inner VLAN 802.1p priorities to different outer VLAN 802.1p priorities, you can perform
the following configuration. For more information about QoS policies, see ACL and QoS Configuration
Guide.
To configure an inner-outer VLAN 802.1p priority mapping policy:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a class and enter class
view. traffic classifier tcl-name [ operator
{ and | or } ]
By default, the relationship
between the rules in a class is logic
AND, that is, the switch considers
a packet belongs to a class only
when the packet matches all the
rules in the class.
3. Define an inner VLAN 802.1p
priority match criterion. if-match customer-dot1p
8021p-list You can configure more match
criteria as needed.
4. Return to system view. quit N/A
5. Create a traffic behavior and
enter traffic behavior view.
traffic behavior behavior-name N/A
6. Configuring the action of
setting the 802.1p priority.
remark dot1p 8021p
Configure more actions for the
traffic behavior as needed.
7. Return to system view. quit N/A
8. Create a policy and enter
policy view.
qos policy policy-name N/A
9. Associate the traffic class with
the traffic behavior. classifier tcl-name behavior
behavior-name
N/A
10. Return to system view. quit N/A
11. Enter interface view:
• Enter Ethernet interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either command.