Enabling gvrp compatibility, Displaying and maintaining mvrp – H3C Technologies H3C S12500 Series Switches User Manual
Page 254

241
Timer Lower
limit
Upper limit
LeaveAll
Leave timer on each port
32760 centiseconds
NOTE:
•
The MRP timers apply to all MRP applications, for example, MVRP, on a port. To avoid frequent VLAN
registrations and deregistrations, use the same MRP timers throughout the network.
•
Each port maintains its own Periodic, Join, and LeaveAll timers, and each attribute of a port maintains
a Leave timer.
Enabling GVRP compatibility
MVRP can be compatible with GVRP. When the peer device supports GVRP, you can enable GVRP
compatibility on the local end, so that the local end can receive and send MVRP and GVRP protocol
packets at the same time.
To enable GVRP compatibility:
Step Command
Remarks
1.
Enter system view
system-view N/A
2.
Enable GVRP
compatibility
mvrp gvrp-compliance
enable
By default, GVRP compatibility is disabled.
NOTE:
•
With GVRP compatibility enabled, MVRP can work with only STP or RSTP rather than MSTP. In this case,
if MVRP and MSTP run at the same time, the network might fail to work correctly.
•
With GVRP compatibility enabled, H3C recommends disabling the Periodic timer for MVRP. Otherwise,
the VLAN status might change frequently when the system is busy.
Displaying and maintaining MVRP
Task Command
Remarks
Display the MVRP status of
the specified port and each
MVRP interface in the
specified VLAN.
display mvrp state interface interface-type
interface-number vlan vlan-id [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display the MVRP running
status.
display mvrp running-status [ interface
interface-list ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display the MVRP statistics.
display mvrp statistics [ interface
interface-list ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display the dynamic VLAN
operation information of
the specified port.
display mvrp vlan-operation interface
interface-type interface-number [ | { begin
| exclude | include } regular-expression ]
Available in any view.