Ensemble Designs 7555 HD / SD Video Processing Frame Synchronizer - Manual (Page 45)

www.ensembledesigns.com Avenue 7555, 9550, 9550-XA - Page 45
7555 HD/SD, 9550 3G/HD/SD, and 9550-XA 3G/HD/SD Video Processing Frame Synchronizers
Using the In 1:4, In 5:8, In 9:12, In 13:16 Menus for Embedding
Routing the Audio into the Module
Route the audio into the module through the AES BNC inputs (for digital audio) and/or through the
15-pin D connector (for analog audio).
Important! Before you can use the 15-pin D connector for analog audio, you must first install
jumper connectors onto the board. See Configuring the Analog Audio and Balanced Digital Data
Jumper Connectors on page 10 for details.
Selecting and Configuring Incoming Audio Pathways to the Mixer
Use the In 1:4, In 5:8, In 9:12 and In 13:16 menus to tell the module to which mixer channels you
want to direct each pair of audio channels. In this example, we are referencing the In 1:4 menu.
However, the same principles apply to the In 5:8, In 9:12 and In 13:16 menus.
For embedding, select AES or Analog for the 1/2 Input and 3/4 Input controls. With the corresponding
drop-down controls to the right, select the pair of audio channels that you want to send to mixer input
channels 1/2 and 3/4. In the example shown below, audio channels 5/6 from the incoming AES signal
will go to mixer input channels 1/2. Similarly, audio channels 7/8 from the incoming AES signal will go
to mixer input channels 3/4.
In 1:4 Avenue PC Menu from the 7555 and 9550 modules showing audio being directed
from AES connectors 5/6 and 7/8 to mixer input channels 1/2 and 3/4. The 9550-XA
module offers two additional pairs (9/10, 11/12) of AES channels.