AML M7220 Wireless Terminal - Manual (Page 47)

2-21
USER’S GUIDE M7220 Wireless Hand-held Terminal
Complete M7220 Option Parameters - cont’d.
Section Setting Parameter Available Options Option Description
Scanner Setup Type ID
Custom Character 1
Term Char 2
Custom Character 2
Scan Angle (Standard
High Speed Laser only)
Illumination
(2-D Imager Only)
LED Power
(2-D Imager Only)
AIM Mode
(2-D Imager Only)
1.) Disabled
2.) AML
3.) AIM
1.) Disabled
2.) Tab
3.) CR
4.) LF
5.) Fexit
6.) Custom
Min: 0 (decimal ASCII)
Max: 255 (decimal ASCII)
1.) Disabled
2.) Tab
3.) CR
4.) LF
5.) Fexit
6.) Custom
Min: 0 (decimal ASCII)
Max: 255 (decimal ASCII)
1.) Narrow
2.) Wide
Enabled/Disabled
1.) Off
2.) Low
3.) High
1.) Disabled
2.) Concurrent
3.) Interlaced
Do not send a type ID character
Prefix AML Type ID
*See AML Type ID Table
Prefix AIM Type ID
*See AIM Type ID Table
No termination character
Append ASCII Tab (0x09)
Append ASCII Carriage Return
(0x0d)
Append ASCII Line Feed (0x0a)
Append Field Exit / ASCII Vertical
Tab (0x0b)
Use custom character
Set termination character 1 to the
ASCII decimal equivalent
No termination character
Append ASCII Tab (0x09)
Append ASCII Carriage Return
(0x0d)
Append ASCII Line Feed (0x0a)
Append Field Exit / ASCII Vertical
Tab (0x0b)
Use custom character
Set termination character 2 to the
ASCII decimal equivalent
Set raster angle to 35 degrees
Set raster angle to 47 degrees
Enable LED Illumination of bar
code
0% LED brigtness
50% LED brightness
100% LED brightness
Disable aiming bar
Illumination LEDs on continuously,
aimer disables on exposure (NOT
RECOMMENDED DUE TO
POWER COMSUMPTION)
Illumination LEDs only on during
exposure, aimer only on in
between exposures