Alinco DJ-S17 - Manual (Page 46)

8.Set Mode
8
46
8.3.12 Menu 12 Tone Squelch Setting
Refer to "Setting the Tone Squelch" on page 37.
8.3.13 Menu 13 Tone Frequency Setting
Refer to "Setting the Tone Frequency" on page 37.
8.3.14 Menu 14 DCS Setting
Refer to "Setting the DCS" on page 38.
8.3.15 Menu 15 APO (Auto-Power-Off) Setting
Refer to "Setting APO" on page 35.
8.3.16 Menu 16 Skip Channel Setting
Refer to "Setting Skip Channels" on page 33.
8.3.17 Menu 17 ATT (Attenuator) Setting
Refer to "ATT (Attenuator)" on page 40.
8.3.18 Menu 18 Battery Charge Function
The Ni-MH battery pack can be charged with an external power supply or an optional
AC adapter using the DC-jack on the unit. Please select ON to activate this function.
The factory setting is ON.
1. CHG-ON is displayed on the LCD.
2. Rotate the dial to select the battery charge setting on and off.
3. Please be sure to read "Battery Type Setting " (page 47) to correctly use this function.
Caution
• Please be sure to select OFF when using a dry cell case otherwise it may
risk a leak of battery liquid, heat or explosion of the battery cells and the
battery case.
• While this function is activated, without attaching a battery pack or the
remaining battery level is below the usable range, the unit turns on by just
connecting the DC source such as an adapter or a DC cable (without
operating the power key). Therefore, leaving the battery pack detached from
the unit may cause the charging terminals on the back of the unit to short
out. Please be very cautious when you operate with an external DC source.