Alinco DJ-S17 - Manual (Page 38)

6.Selective Calling
6
38
6.1.3 Switching Off the Tone Squelch
Select TN-OFF in the menu 12 of the Set mode, and press any key other than the
MONI or FUNC key to complete setting.
6.1.4 To Differentiate the ENC/DEC Tones
To set the encoding and decoding tones independently, perform the following settings.
1. To set the encoding tone, while is displayed in the setting menu 12, press the FUNC
key to move to the menu 13 and select a desired encoding tone by rotating the dial.
2. Press the MONI key to go back to the menu 12 then rotate the dial clockwise to
select TN-TSQ. Press the FUNC key to move to the menu 13 again and select a
desired decoding tone frequency using the dial.
3. Press the PTT key to return to the operating mode or the FUNC/MONI keys to
continue with setting programming in the Set mode.
6.1.5 Tone Squelch Operation
The squelch unmutes only when the signal with the same decoding-setting tone is
received.
6.2.1 Setting the DCS
1. Select the menu 14 in the Set mode to display the current DCS setting. The initial
setting is DCS-OF.
Rotating the dial, the display switches between:
2. Press any key other than the MONI or FUNC key to complete the setting. Observe
that " " is displayed.
DCS DCS
DCS-OF 023 754
DCS 6.2