Alinco DJ-S17 - Manual (Page 30)

4.Basic Operation
4
30
This mode is used to recall a most frequently used memory channel (stored in MC
channel) with a single key-touch.
1. Press the key.
" " is displayed on the LCD, and the channel
programmed in MC is recalled.
2. Press the key again in the Call mode to return
to original operating mode (VFO/memory).
1. Turn on the unit.
2. Press the key and rotate the dial to adjust the audio level as necessary.
3. Press the key and rotate the dial to adjust the squelch level.
4. Select the frequency that you wish to operate by using the dial. When a signal is received
on the frequency that you selected, and S-meter are displayed on the LCD, then
the received signal can be heard. The green RX indicator also lights at this time.
4.7.1 Monitor Function
In case the receiving signal is weak and the audio is intermittently cut off by the
squelch, press the MONI key. As long as this key is pressed, the squelch including
TSQ/DCS unmutes making the audio easier to hear.
• The squelch is unmuted while the MONI key is pressed, regardless of the squelch
level setting.
• This function unmutes the squelch even if the DCS and Tone Squelch functions are set.
Receiving 4.7
IMPORTANT NOTE:
• The dial operation of frequency/memory channel is blocked in the Call mode.
• It is possible to temporary change the offset and CTCSS/DCS related
parameters in the Call mode by entering to the Set mode in the Call channel.
• The Scan function is deactivated in the Call mode.
• The CALL channel reprogramming is possible but it can't be deleted from the
memory channel mode.
NOTE:
Refer to "How to Program Call Channel" on page 28 for programming Call channel.
Call-Channel Mode 4.6