Alinco DJ-S17 User Manual
Page 28
4.Basic Operation
4
28
4.5.2 Recalling a Memory Channel
1. Select the Memory mode by pressing the
key. "
" and channel number
appear on the display to indicate that the unit is in the Memory mode.
Repeat to switch between the Memory, Call channel and VFO modes.
2. Select a memory channel.
Rotating the main dial will increase or decrease a memory channel number.
4.5.3 Deleting a Memory Channel
1. Select the Memory mode by pressing the
key.
2. Rotate the dial to select the memory channel No. that you wish to delete.
3. Press the FUNC key, and while
is displayed on the LCD, press the
key. A
beep sounds, then "
" flashes on the display. If
disappeared before pressing
the
key, press the FUNC key again and then
key.
4.5.4 How to Program Call Channel
1. Select the Memory mode by pressing the
key. "
" appears on the display.
2. Rotate the dial to display " ".
3. Press the
key twice to switch to the VFO mode, and rotate the dial to select the
desired frequency and set other parameters.
4. Press the FUNC key and while
is displayed, press the
key. A beep sounds
and programming is completed. If
disappeared before pressing the
key,
press the FUNC key again and then
key.
4.5.5 Programming a Repeater-Access Function Setting
The "Repeater-Access" function is to set the desired shift and tone parameters to the current
operating frequency by just 2 key-touches. Parameters programmed in the Repeater-Access
function memory can be used in any of the VFO/Memory/Call channel modes.
Although parameters programmed in the Set mode are maintained at any frequency,
those programmed in the Repeater-Access function memory are applied to the
operating frequency only by using the Repeater-Access function (page 41). Thus, it is
recommended that you use this function in amateur radio where you communicate by
frequently switching between simplex and semi-duplex operations.
NOTE:
When "
" is flashing in step 3 (when the memory contents are displayed as is
on the display), it is still possible to cancel the operation by pressing the FUNC
key, and while
is displayed on the LCD, press the
key. After changing
channels or modes, this is no longer possible.