Alinco DJ-S40 - Manual (Page 38)

34
8. Cloning
■ Receiving the Master Data
1."Ld
✽✽✽" appears on the slave
transceiver's display while the master
data is transmitted.
"Ld 078" remains displayed when the
cloning is completed.
The receiving side cannot recognize
whether the data has been transmitted
correctly. Check to see if "PASS" is
displayed on the transmitting (master)
side.
2. Switch the transceiver power OFF.
Caution • Do not disconnect the cable while cloning.
• All data in the slave transceiver will be updated to the master
transceiver's data during the cloning operation. Be sure you
want to change everything before cloning.