Alinco DJ-S40 - Manual (Page 35)

31
7.Special Functions
7-1-3 Alarm Delay
When this function is set, the alarm
starts sounding after an interval.
1. Set the alarm function to "SCr-dL"
in Setting mode "17".
2. Insert the plug of the alarm cable, and
turn the power of the transceiver
OFF.
In this setting, the alarm will not
sound until 10 seconds after the plug
is detached.
If the cable is detached during the
alarm setting procedure, the alarm
will start sounding 10 seconds later.
Caution • It is recommended that you use the tone squelch when setting
the CH-SC (for alarm), since there is the considerable
possibility that the alarm setting could be canceled by reception
of any random signal.
• Set the alarm function off (SCr-oF) during regular
operation.
• If the CH-SC (for alarm) memory is not programmed, you
can stop the alarm by sending a signal on the same frequency
appearing on the display, in the VFO mode.