Adjustment attributes, Nvr 3.0 system administrator’s manual – ACTi NVR 3 V3.0.09 User Manual
Page 65
NVR 3.0 System Administrator’s Manual
Adjustment Attributes
Field Name
Description
Vendor
Vendor is the provider of Protocol. The selectable vendors would vary
depending on different device models.
Protocol
Protocol is a set of rules to define the communication format between the
device and controller. Different protocols are provided for selection according to
the Vendor you choose.
Parity
Parity is the data validation mechanism for analog devices that use serial port
interface to send or receive data. When choosing parity mode other than
"none", the data packets will be validated for possible data losses so that failed
command could be re-sent if necessary. Please refer to the parity setting of the
analog device and choose exactly the same parity setting also in NVR. When
setting up ACTi Zoom, PTZ or Speed Dome cameras using
“ACTi”
protocol, you may ignore the parity setting.
Available parity modes are:
Parity mode name
in NVR
Serial data,
represented by given
amount of bits
Parity mode
(none, odd, even)
Number of stop
bits
8N1
8
N
1
8O1
8
O
1
8E1
8
E
1
8N2
8
N
2
8O2
8
O
2
8E2
8
E
2
7N2
7
N
2
7O2
7
O
2
7E2
7
E
2
Baud rate
Baud rate defines the data speed through serial port interface
– the rate value
represents the number of symbols that can be transmitted within 1 second.
Please refer to the baud rate setting of the analog device and choose exactly
the same baud rate setting also in NVR. When setting up ACTi Zoom, PTZ or
Speed Dome cameras using
“ACTi” protocol, you may ignore the baud
rate setting.
Address ID
Address ID represents the identity of the device, only analog devices or speed
dome cameras require this configuration. Please refer to the Address ID of the
device and choose exactly the same baud rate setting also in NVR 3.0.
Available value is from 1~99. By default, ACTi devices
will use “1” as Address
ID, it is suggested not to change it.