Configure storage card settings – ACTi NVR 3 V3.0.09 User Manual

Page 63

www.acti.com

NVR 3.0 System Administrator’s Manual

Configure Storage Card Settings

Certain camera models come with the internal storage feature. Via NVR interface, you can

observe the storage card’s memory status, and configure related settings.

1. Make sure the SD card is installed properly in the camera.

2. On Setup page  Device tab, select the device form Device List

. Click “Storage”.

3. On Storage

window, click “Get Storage Setting” to sync with the SD card.

You can enable “Redundant Recording when Disconnected” function to have this

SD card take over the recording service for this channel when this device is

disconnected with NVR server. The video recorded on SD card during the

disconnection period will automatically be restored back to NVR server upon the

recovery of the connection. Click

“Apply” to save the setting.

Note

Before you enable “Redundant Recording when Disconnected” function, please do the
following (1) upgrade the camera firmware to 6.07 or later version, and then (2) format the SD
card either on camera firmware interface or on NVR interface.