Welltech WG5260 V.6.1 - Manual (Page 76)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.1.0 - 76 -
• SNTP Server: The SNTP server list. You can use; or, to have multiple
SNTP server.
• Polling interval (second): How long the SNTP will synchronize the time
from the SNTP server in seconds.
• Min Retry Interval (second): This is the initial retry interval. Each retry will
multiple 2. For example, the Min Retry Interval is 10 and Max Retry
Interval is 600. The retry sequence will be 10, 20, 40, 80, 160, 320
seconds.
• Max Retry Interval (second): This is the max time to wait before attempting
a retry.
• Max Adjust Time (second): If this is zero, the SNTP client will be willing to
apply any size time adjustment. If this is non-zero, then any time
adjustment greater than this will be considered an error.
• NTP Server Port: This is the port number the SNTP client will attempt to
connect to on the time server. The default value is 123.
• Local NTP Port: This is the port number that will use to listen for replies
from the server. The default value of 0 means use a random port number.
• Packet Error Check: If this is disabled, then the validity checks are
suppressed. The default value is enabled.
Network
DNS Server Setting:
Step 1: After successfully logon to the system, we need to change the
network configuration. Click Control > Network to setup the network
parameters as figure 8.3-1.
Figure 8.3-1
Parameter:
• Primary DNS Server: Primary DNS Server IP network
• Secondary DNS Server: Secondary DNS Server IP network
• Host Name: Host name used to register to DNS Server
• Domain Name: Domain name used to
• Dynamic DNS Registration: Enable Dynamic DNS registration or not