Welltech WG5260 V.6.1 - Manual (Page 71)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.1.0 - 71 -
Routing Plan
The purpose of Routing Plan is to select T1/E1 trunk and channels by
your preference when there is a call from IP side to PSTN side. The PSTN
must be used in call flow edit or line hunting component to take effect.
Hunting Group
Start Path: Configuration>Routing Plan>Hunting Group
Figure 7.8-1
Parameters:
• Group ID: Hunting Group ID
• Description: Description of Hunting Group
• Hunting Method: Route selection
- Random: Random select a trunk within this hunting group
- Priority: Select a trunk by priority. (Priority 1 has lowest priority; 9
has highest priority)
- Round Robin: Call is hunting rotationally
Start Path: Configuration>Routing Plan>Hunting Group>Detail
Figure 7.8-2
Parameters:
Group: 1 Description: 0932
• Interface ID: Interface ID
• Trunk ID: trunk id for group 1
• Priority: Trunk priority
• Channel Mask: Channel mask for incoming or outgoing calls (refer
T1/E1 Trunk Configuration )
☺ Note: When a Route Plan channels mask is cooperated to trunk
channel mask to decide the channel availity 17~31 channels are
available:
Example 1:
Trunk ID: 0 channel mask: 0xffffffff
Route Plan channel mask: 0x0000ffff
Available channel: 0x0000ffff (17~31) channels.
Example 2:
Trunk ID: 0 channel mask: 0xffff0000
Route Plan channel mask: 0xffc00000
Available channel: 0xffc00000 (1~9) channels.