Welltech WG5260 V.6.1 - Manual (Page 34)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.1.0 - 34 -
Make Call: Make Call to PSTN or H.323/SIP site
o
Route Mode: Gatekeeper Call or P2P Call or PSTN…etc. (for PSTN
incoming call, please select the Gatekeeper, P2P Call, or SIP Proxy
call
TA; for H.323/SIP incoming call, please select the PSTN call)
o
Use Proxy: When the Route Mode is SIP Proxy Call, the Use Proxy
will be available. You need to specify the Proxy ID that you are
going to used for making calls.
o
VOIP Hunting Group: When the Route Mode is P2P Call, the VOIP
Hunting Group will be available. You need to specify the VOIP
hunting group defined in VOIP hunting.
o
Transport Address: When used for “H.323 TA” routing mode, the
format used is “Ipaddr: port” (e.g. 192.168.111.50:1720). If the
target address is SIP, the format is “sip: xxx@xxxx”.
o
Active Disconnect: Enable PSTN user can actively disconnect the
call or not
o
Active Disconnect Digit: The DTMF digit to be tread as the
disconnect trigger. Only can be used “Active Disconnect” enable
o
Active Disconnect To: The next component when active disconnect
is occurred
o
Inter Digit Timeout: The max time to in seconds to wait between two
digits.
o
RTP Route: Voice RTP routing over WG5260 or not, for VoIP to
VoIP call
o
Finish To: Successfully connect to remote site
o
Failed Other to: The next component when default failed call
o
Failed Reason: Failed reason selection
o
Failed To: When the failed reason occurred go to
o
Line Propriety:
-PSTN: PSTN disconnect reason code: