Welltech WG5260 V.6.1 - Manual (Page 135)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.1.0 - 135 -
Answer:
a. In H.323 Mode: Make sure WG5260 and other endpoint use same
DTMF relay mode (e.g. H.245 Alphanumeric.)
b. In SIP Mode: Make sure WG5260 and other endpoint use same
DTMF relay mode (e.g. SIP Info or RFC2833-payload type.)
c. In SIP Mode: Make sure the remote SIP end point’s RTP payload type
is supported or not.
d. If use Q.931 UUI DTMF Relay mode, make sure Gatekeeper can
correctly forward Q.931 UUI when registering to Gatekeeper is set to
true.
Q11. Does WG5260 can cooperate with the Cisco VoIP products?
Answer:
The short answer is “yes”. The following configuration example can be
used for normal and fax call.
Example for H.323 Mode
Voice service voip
Fax protocol t38 ls-redundancy 1 hs-redundancy 1
Voice class codec 100
Codec preference 1 g723r63
Codec preference 2 g729r8
Codec preference 3 g711ulaw
Codec preference 4 g711alaw
dial-peer voice 100 pots
application session
destination-pattern 8001
progress_ind progress enable 8
port 1/1/0
dial-peer voice 200 voip
destination-pattern 2T
voice-class codec 100
session target ras
dtmf-relay h245-signal h245-alphanumeric
fax rate 14400
fax-relay ecm disable
fax protocol t38 ls-redundancy 1 hs-redundancy 1
no vad
Example for SIP Mode
voice service voip
fax protocol t38 ls-redundancy 1 hs-redundancy 1
dial-peer voice 300 voip
destination-pattern 20T
rtp payload-type nte 110
voice-class codec 88
session protocol sipv2
session target ipv4:192.168.5.205
dtmf-relay rtp-nte
fax-relay ecm disable