Welltech WG5260 V.6.1 - Manual (Page 57)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.1.0 - 57 -
on NT-side. This have been identified as solving a problem with
Coral PBX that requests a Channel in the first respond to an
incoming call from it .
o
0x00001000: When this bit is set, the ISDN Stack does NOT
automatically generate a Setup Ack. When this bit is not set, the
ISDN Stack sends a Setup Ack when it detects overlap receiving in
progress.
o
0x00002000: When this bit is set, the ISDN Stack forces the
sending of Channel-id Information Element (IE) in the Call-
Proceeding message. When this bit is not set, the ISDN Stack
forces it only if it is mandatory for the running operator or if on NT-
side.
o
0x00010000: When this bit is set, the board automatically sends a
Progress-Indicator #8 (“in-band tones/announcements available”) in
the Setup-Ack message that is sent back automatically by the board
when it receives and accepts a Setup message in overlap-receiving
mode (e.g no digit in the Setup), for Voice calls only (BC encoded
as Speech or 3.1-Audio). This enables tone generation to the
Terminals after handset off-hook.
• Q.931 Outgoing Opt.: used for Q.931 outgoing behavior
o
0x00000002: Automatic generation of ‘Sending-complete’
information element in SETUP (as result of Place Call)．When this
bit is set, Board does not generate automatically the 'Sending-
complete' information element in the SETUP. The User application
must request it in the Place Call function. Otherwise (if this bit is not
set), the Board generates it automatically in the SETUP message
only.
o
0x00000010: use Mu-law if this bit is set, or A-law will be used.
Apply only for Korea variance, you can OR the required option
together.
o
0x00000080: When this bit is set, ISDN stack uses the KEYPAD IE
to store the called number digits instead of the CALLED_NB IE.
Only is applicable for KOR variant (Korean network). That is Useful
for Korean switches do not accept the Called number IE.
o
0x00000100: When this bit is set, ISDN Stack forces the sending of
a Channel-id IE in an outgoing SETUP message even if it is not
required by the standard(i.e., it is optional only ), and no Channel-id
was specified in the establishment request. This is useful to
increase compatibility with switches that require it. On PRI lines it
indicates a not yet used channel id, preferred only.
o
0x00000200: When this bit is set, ISDN Stack sends G.711 A-Law
in outgoing voice calls. When this bit is cleared, ISDN Stack sends
default G.711-Mu-Law in outgoing voice calls. Applicable for 5ESS
variant (T1).
• Trans Cap: Transfer Capability
o
Voice Service
o
Data Service
o
Modem Service
• Call ID Transfer Type: Call ID transfer type
o
Disable Caller ID: default parameter