Welltech WG5260 V.6.1 - Manual (Page 72)

Welltech Computer Co., Ltd.
WellGate 5260 User Guide – V6.1.0 - 72 -
Call Routing
The call routing can be used for hunting a PSTN trunk by prefix.
Start Path: Configuration>Routing Plan>Call Routing
Figure 7.8-3
Parameters:
• Group ID: Select the T1/E1 according to the selection of Hunting Group
ID when dialed number is matched
• Number To Route: The dialed telephone number to be matched
• Matched ANI Prefix: Calling party number used to filter
• Allow Use Others: To select other T1/E1 trunk when all trunk are busy
at your desired Hunting Group.
- Allowed: The call will use other T1/E1 trunks which is not belong to
the selected hunting group
- Forbad: The call will be disconnected immediately
Radius Setting
When you have an external RADIUS server to do the AAA (Authorization,
Authentication and Accounting), enter the correct parameter to the Radius
setting. It must be used in call flow to take effect.
Start Path: Configuration>Radius Setting
Figure 7.9-1
Parameters:
• Auth IP: Radius Authentication Server IP address (default)
• Auth Port: Radius Authentication Server Port
• Acct IP: Radius Account Server IP address
• Acct Port: Radius Account Server Port
• Backup Auth IP: Backup Radius Authentication Server IP address
• Backup Auth Port: Back Radius Authentication Server Port
• Backup Acct IP: Back Radius Account Server IP address
• Backup Acct Port: Back Radius Account Server Port