Visara 410 - Manual (Page 19)

3-1 707027-002
Chapter 3: Starting Visara the First Time
Chapter 3: Starting Visara the
First Time
Windows Setup Wizard
The first time the Visara is run the user will be presented with the Windows-
Based Terminal setup wizard. The setup wizard welcome screen shows
the product ID at this screen, click Next to continue the setup function.
The setup wizard will then present the Microsoft Windows CE license
agreement. You should read this agreement and click Accept to continue
the setup process.
Depending on your use of DHCP, the setup wizard will present a screen
asking if you wish to use the DHCP settings or to configure a manual
DHCP address. If your settings are provided by a DHCP server, select
DHCP and Next to continue. If you will be providing manual settings for
the IP address or other settings see the section on Manual configuration
below. Once the appropriate information is supplied click finish on the
final screen to exit the Setup Wizard. If the Restart Message is displayed
select Yes at the prompt to restart your Visara using the new settings.
Automatic Configuration
The Visara can be configured automatically through the use of a ftp server
on the network and the Visara Remote Configuration Utility. Or, these
functions can be bypassed and the Visara configured manually. Using a
DHCP server will allow use of the Visara without configuring the network
parameters such as an IP address or Gateway address. The Remote
Configuration Utility is used to configure the connections to other network
servers such as telnet terminal emulations. The Visara comes pre-
configured to use DHCP and Remote Configuration to allow fully
automatic installation without operator intervention. The steps for
automatic and manual configuration are covered below: