Visara 1174-65S - Manual (Page 38)

32
1174-65S/90S Communications Servers Hardware Reference Manual
707020-002
Floppy Disk Drive
The following procedure describes removing the 3.5-inch diskette drive.
Removal
1. Ensure power is off. Remove the covers.
2. Locate and disconnect the drive control and power supply cables.
3. Remove the four screws attaching the disk drive to its bracket. There are two
screws located on each side of the drive bracket.
4. Carefully slide the drive from its bracket.
Replacement
1. Align the disk drive into its mounting track.
2. Carefully slide the disk drive into its bracket.
3. Install the screws to attach the drive to the bracket.
4. Connect the drive control and power supply cables.
5. Replace the covers.
Hard Disk Drive (65S only)
The hard disk drive with bracket is installed in the lower floppy drive bay. The following
procedure describes removing the hard disk drive.
Removal
1. Ensure power is off. Remove the covers.
2. Locate and disconnect the drive control, fan, and power supply cables.
3. Remove the four screws attaching the disk drive to its bracket. There are two
screws located on each side of the drive bracket.
4. Carefully slide the drive from its bracket.
Replacement
1. Align the disk drive into its mounting track.
2. Carefully slide the disk drive into its bracket.
3. Install the screws to attach the drive to the bracket.
4. Connect the drive control and power supply cables and DC fan power cable.
Note: Ensure the drive control cable is properly attached to J12 on the Mother
board.
5. Replace the covers.
6. Execute Offline Utility 36 to initialize the drive.