Visara 1174-65S - Manual (Page 31)

25
Chapter 4. Operation
707020-002
where: XCP indicates an exception error.
JSS indicates the physical slot number of the board where the error occurred.
BB shows the board ID in hexadecimal format.
EEE shows the type of exception error.
* indicates additional messages that give more information about the error (not always present).
Problem Determination contains additional information about Exception errors.
If unable to correct the problem, prepare a dump disk of the error information, Problem
Determination “Utility 20” and then call the next level of technical support.
Hardware Failures (FAIL ___)
Hardware failures show specific hardware problems. They may occur during IML or testing
mode. Code verification errors may also display as a hardware failure.
Error messages display on the operator panel as shown below:
Hardware - FAIL JSS:BB:TNN*
Code Verification - FAIL JSS:BB:MOV*
where: FAIL indicates a hardware error.
JSS is the slot number of the failing board.
BB shows the board type ID in hexadecimal format.
T is the failing test type.
NN is the failing test number.
MOV indicates that the diagnostic code a processor board moved to its local memory does
not match the code from where it was moved.
* indicates additional messages that give more information about the error.
Problem Determination, Hardware Failures, and Off-line Testing, contain additional
information about Hardware failures.
Online Errors
Online errors show problems that occur while the Communications Server is online with its
host and attached devices. Online error numbers may appear on the operator panel (some
300- and 500-type errors only), preceded by an indication of which attached host system is
involved, and may be displayed on an attached display’s status line preceded by X. Problem
Determination describes Online errors and recovery procedures.