Visara CCA-3074 Planning Guide - Manual (Page 48)

Chapter 4. IOCDS Sample Definitions
4-4 707159-002
EXAMPLE 2 - Typical 3174 Replacement (FICON)
This example shows the replacement of the same two ESCON attached 3174s from
Example 1, with a single CCA-3074 (this time on FICON). The definitions for the two
3174-22L were given in Example 1. The definitions below are used to connect the CCA-
3074 through FICON.
CCA-3074 Definitions
RESOURCE PARTITION=((LPAR390,1),(TEST1,2))
CHPID PATH=(1E),TYPE=FC,SWITCH=01,SHARED
CNTLUNIT CUNUMBR=IEOO,PATH=1E,UNITADD=((00,5)),UNIT=NOCHECK
CNTLUNIT CUNUMBR=IFOO,PATH=1E,UNITADD=((00,5)),UNIT=NOCHECK
IODEVICE CUNUMBR=IE00,ADDRESS=(600,5),UNIT=3270-X,UNITADD=00,PARTITION=(TEST1)
IODEVICE CUNUMBR=IF00,ADDRESS=(600,5),UNIT=3270-X,UNITADD=00,PARTITION=(LPAR390)
Notes:
1. MIF is used to allow both CNTLUNITs to share the same path (1E).
2. The CNTLUNIT macros do not include the CUADD parameter, and the default
value of “0” is assumed.
3. This time the CHPID type is FC (FICON)
4. Note that the UNIT type has changed to ‘NOCHECK’. TYPE=3174 is not valid in the
FICON environment.
LPAR390 TEST1
1E
1F
LPAR390 TEST1
1E
MIF
Before After