Visara CCA-3074 Planning Guide - Manual (Page 15)

CCA-3074 Planning
707159-002 2-1
Chapter 2. Planning for Your Install
Identifying the Non-SNA Environment
First, take a moment to fill out the following worksheet to determine
what your environment is, or what you wish to create. Several topic
paragraphs are provided to help determine what is needed to satisfy
your requirements. Finally, a worksheet at the back of this book may
be used to map out your configuration prior to actually attempting to
configure the CCA-3074. You may want to create a spreadsheet with
a similar layout or make several copies of the worksheet to
encompass your entire configuration requirement.
Number of mainframes? Number: _______
Number of LPARs? Number: _______
EMIF supported on any of the mainframes? (Yes/No) _______
ESCON/FICON Directors being used? (Yes/No) _______
Operating Systems in use? (OS/390, MVS/ESA, VM/ESA,
VSE/ESA)
_______
Coax Terminal Requirement ________
StorageTek LMUs (Yes/No) _______
IBM 3290 (Yes/No) _______
Redundant Console Controllers (Yes/No) _______
Number of consoles needed for each LPAR Number: _______
Need/desire to use one console for multiple LPARs (Yes/No) _______
Need to display multiple LPARs at once on a display (Yes/No) _______
Remote Access requirement? (Yes/No) _______
Hot Console session requirement (Yes/No) _______
Shared session requirement (Yes/No) ________
For FICON installs, are Long Wave or Short Wave interfaces required ________