Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 65)

W e b S e r v e r I n t e r f a c e 3-37
Figure 3.34 Rule Config Screen
The paragraphs below describe the rule configuration parameters and their
options.
S erv ice Selects the service to which the rule applies. Select from a pull-down menu
that lists available services.
V P I Selects the VPI to which the rule applies.
V C I Selects the VCI to which the rule applies.
F ilter B y V P I/V C I Enables or disables filtering of the IP traffic in accordance with the specified
VPI/VCI.
NOTICE: To use this filter, you must specify both the Service and VPI/VCI
parameters in the Rule Config screen.
IP A d d ress Establishes the IP address by which the rule will filter IP traffic (if enabled).
IP M a sk Represents a range of IP addresses defined so that only machines with IP
addresses within the range defined by the mask are allowed to access an
Internet service. To mask a portion of the IP address, replace it with the wild
card character “0” (zero). (For example, 192.44.0.0 represents every computer
on the Internet with an IP address beginning with 192.44.)
F ilter B y IP A d d ress Enables or disables filtering of the IP traffic by the IP address specified in the
IP Address or IP Mask field.
IP P ort Establishes the IP port by which the rule will filter IP traffic (if enabled).
F ilter B y IP P ort Enables or disables filtering of the IP traffic by the IP port specified in the IP
Port field.