Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 24)

1-8 W A N s u i t e 6 x 3 0
into the unit’s POWER port and then connect the wall plug to an appropriate
electrical outlet. The unit has no power switch.
When power is applied to any WANsuite 6x30 unit, the front panel indicators
flash for approximately 10 to 15 seconds as the unit initializes. The green
POWER LED on the front panel will remain illuminated as long as the unit
receives power. This LED turns amber when the unit is in test mode.
CAUTION: Always connect the power cord to a grounded electrical outlet.
NOTICE: Per UL 1950 and CSA 950 Clause 1.7.2, if the power supply cord is
intended to serve as a disconnect device, an easily accessible socket
must be installed near the equipment.
Power Failure
If the indicator does not illuminate, check the power connections and the
primary circuit breaker.
The WANsuite 6x30 units provide nonvolatile memory retention of the unit
configuration in case of a power failure. The unit will automatically restore
normal service following a power loss and will retain pre-existing time and
date information.