Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 57)

W e b S e r v e r I n t e r f a c e 3-29
Figure 3.25 Confirm Delete Service Screen
IP Service Details Screen
Access the IP Service Details screen by clicking the IP link under the Type
column on the Services screen. Both the IP Service Details and the Ethernet
Stats screens are described on page 3-25.
ATM Service Details Screen
Access the ATM Service Details screen (Figure 3.26) by clicking on ATM
under the Type column on the Services screen. The ATM Service Details
screen lets you access the configuration parameters described in the
paragraphs below.
Figure 3.26 ATM Service Details Screen
The Configuration table on the ATM Service Details screen is used to set the
following configuration parameters:
•
Max VCC (Virtual Channel Connection) – Represents the maximum number
of Virtual Channel Connections on this ATM link. By default, each VCC will
equally share the available bandwidth. This value should be kept as low as
possible to avoid wasting bandwidth. The default value is 4.