Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 133)

V T 1 0 0 I n t e r f a c e 4-35
T x A larm T h resh old Specifies the threshold in bits per second for the Transmit Alarm on this rule.
T x A la rm Displays the current Transmit Alarm status.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen displays the number of frames and octets
sent over a VPI/VCI that have been counted in accordance with the Service
Aware “rule” that has been established for a Service. As such, it is
ATM
specific (i.e., VPIs/VCIs only occur in ATM links). In addition, this screen
provides data rate performance information for the period of time specified in
the field (see below).
Figure 4.31 Traffic Meter Statistics Screen
The Traffic Meter Statistics screen reports on the following parameters:
• Tx Frames
•
Tx Octets
• Rx Frames
•
Rx Octets
• Rate Peak – the peak data rate for the viewed period (see below)
•
Rate Average – the average data rate for the viewed period (see below)
The “Period” refers to the period of time for which the Traffic Meter statistics
are reported as listed below.
S u m m a ry Represents the past 24 hours; reports the additive number of frames/octets, the
highest peak encountered for 24 hours, and the average for 24 hours.
C u rren t Reports on the current 15-minute interval.
In terva l 1,
In terv al 2,...,
In terv al 96
Reports on Intervals 1-96, which correspond to the periods completed 15
minutes ago, 30 minutes ago,..., 24 hours ago.