Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 116)

4-18 W A N s u i t e 6 x 3 0
Figure 4.15 Span Endpoint Details Screen
Ven d or ID Vendor ID as reported in an Inventory Response message.
M od el N u m b er Vendor model number as reported in an Inventory Response message.
S erial N u m b er Vendor serial number as reported in an Inventory Response message.
E O C S oftw are Versio n Vendor EOC version as reported in a Discovery Response message.
S ta n d a rd Versio n Version of the SHDSL standard implemented as reported in an Inventory
Response message.
L ist N u m b er Vendor list number as reported in an Inventory Response message.
Issu e N u m b er Vendor issue number as reported in an Inventory Response message.
S oftw are Versio n Vendor software version as reported in an Inventory Response message.
E q u ip m en t C od e Equipment code conforming to ANSI T1.213, Coded Identification of
Equipment Entities.
Tra n sm issio n
M od eC ap a b ility
Transmission mode capability of the SHDSL unit.
E n d p oin t S id e Defines which direction the SHDSL port is pointing. Normal operation will
use the TU-R configuration, and the endpoint will be “Network.” When unit
type is TU-C, endpoint will be “Customer.”
W ire P air Always “Wire Pair 1.”
Selecting the “Span Endpoint Maintenance” prompt from the Span Endpoint
Details screen will display the screen shown in Figure 4.16. This table supports
maintenance operations (e.g., loopbacks) to be performed on segment
endpoints.