Verilink WANsuite 6x30 (34-00315.B) Product Manual - Manual (Page 32)

3-4 W A N s u i t e 6 x 3 0
Maintenance Reset
Use this button to perform a Maintenance Reset. All configurations will be
lost and the unit will be set back to the factory default Ethernet or Serial
HDLC configuration. Either default configuration will set up an ATM service
on the Network port, using one configured virtual channel (VPI=0, VCI=32).
Management data received on this ATM channel (either Web or SNMP) will
be processed at the unit if it is encapsulated using RFC 1483 and directed to
the unit’s IP address. (A Maintenance Reset will not change the unit’s IP
address.) The default serial HDLC configuration will also accept PPPoA
encapsulated data and deliver it to the Serial port. Clicking the “Maintenance
Reset” button will display a confirmation screen (Figure 3.2) with the option
to perform either an Ethernet or Serial HDLC reset.
Figure 3.2 Maintenance Reset Screen
NOTICE:
Performing a “Maintenance Reset” or a “Save and Restart” will
terminate communications with the unit. A “Refresh” should be
performed after approximately 10 seconds to restore communications.
Save and Restart
The Save and Restart button on the Unit screen will display the confirmation
screen shown in Figure 3.3.
Save and Restart Saves the current configuration and restarts the unit.
Refresh Refreshes data on the current page.
Button Function