Port diagnostics menu, Port diagnostics menu -11, Table 3-5 – Verilink HDM 2182 (880-502925-001) Product Manual User Manual
Page 33

Standalone HDM 2182 Management
Verilink HDM 2182 User Manual
3-11
Table 3-5
HSSI Port Configuration Submenu Choices
Port Diagnostics Menu
When the node administration parameters have been set and the
ports are configured, limited diagnostics are available with direct
connection to the HDM 2182. From the Main Menu, choose D to
display the Port Diagnostics Menu.
Command Description
S
HSSI Port State—When Configuration Mode (below) is Automatic, the Port State is an
informational display. In Automatic mode the HSSI data port is In Service when DTR is
presented by the DTE and it is Out of Service when the DTE fails to assert DTR.
When Configuration Mode (below) is set to Manual, the Port State command becomes a
toggle. If Mode = Manual and Port State = OUT OF SERVICE, then issuing the Port State
command will place the port IN SERVICE, whether or not any DTE is present and whether or
not it is asserting DTR. Conversely, if Configuration Mode = Manual and the Port State = IN
SERVICE, issuing the Port State command will place the port OUT OF SERVICE, stopping all
user data.
HDM > s
HSSI Port A State: Out of Service
Enter 1) Out of Service 2) In Service) >
M
Configuration Mode—If in Automatic mode, this option detects the connection of HSSI
equipment and its line speed. It then adjusts its line speed and mode accordingly. The
Configuration Mode toggles between Automatic and Manual each time the Configuration
Mode Command is issued.
When Configuration Mode is Automatic, the Port State is an informational display. In
Automatic mode the HSSI data port is In Service when DTR is presented by the DTE and it is
Out of Service when the DTE fails to assert DTR.
When Configuration Mode is set to Manual, the Port State command becomes a toggle. If
Mode = Manual and Port State = OUT OF SERVICE, then issuing the Port State command will
place the port IN SERVICE, whether or not any DTE is present and is asserting DTR.
Conversely, if Configuration Mode = Manual and the Port State = IN SERVICE, issuing the
Port State command will place the port OUT OF SERVICE, stopping all user data.
HDM > m
HSSI Port A Mode: Manual Mode
Enter 1) MANUAL 2) AUTOMATIC) >
R
Change Near End Data Rate (The data rate for the Near End is listed at the top of the HSSI
Port Configuration menu):
HDM > r
Warning!! Config NE only. FE rate could become inconsistent. Change (Y/N)?
A
Scrambling—If enabled, the actual user data is modified in an industry standard method.
This feature has no bearing on encryption or the security of user data. It was added to allow
inter-operation of the HDM 2182 with DS3 products from other manufacturers.
X
exit menu—Returns you to the
Port Configuration Menu